Seat Ateca 2017 Workshop Manual page 371

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Release fasteners -arrow-, and pull wiring duct slightly up‐
wards.
– Unscrew bolts -2- and -3-, and carefully pull coolant line slight‐
ly upwards.
– Lay fuel hose -1- at intake manifold to one side.
CAUTION
The fuel system is pressurised.
Risk of injury due to fuel which may spurt out.
– Wear safety goggles.
– Wear protection gloves.
– Release pressure: place clean cloth around connection and
carefully open connection.
– Release hose clip -2-, and remove coolant hose.
– Vehicles with auxiliary radiators: unscrew bolts -arrows- and
slightly press the coolant line downwards.
– Unscrew retaining clip -arrow- for high-pressure pipe.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
EA 888 III. Gen) - Edition 10.2018
4. Suction hose
363