Seat Ateca 2017 Workshop Manual page 62

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– On both sides of vehicle, insert adapters - 10 - 222 A /29- be‐
tween upper wheel housing longitudinal member and mount‐
ing plate for wing located underneath.
• Installation position:
Attach the "L" adapter to the "right" vehicle side ( adapter clicks
into place in the wiring recess, observing the height -arrow-)
Attach the "R" adapter to the "left" vehicle side ( adapter -1- clicks
into place in the wiring recess, observing the height -arrow-)
– Insert spindle - 10 - 222 A /10- -5-, adapter - 10 - 222 A /18-
-3- and adapter - T40091/3- -2- into the support bracket - 10 -
222 A- -4-.
– Screw on support bracket - 10-222 A- -4- to adapters - 10 -
222 A /29- -1-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– If fitted, pull off electrical wiring in front area of web on both
longitudinal members -arrow-. Do not disconnect pipe/hose
system.
– Place the adapter - T40093/3-6- over the bottom right longi‐
tudinal member.
– Bolt -A- must stay behind the edge -arrow-.
– If necessary, carefully clip off any pipes in the front area for
the air conditioning system. Do not disconnect pipe/hose sys‐
tem ⇒ Heating, air conditioning; Rep. gr. 87 ; Refrigerant
circuit; System overview - refrigerant circuit .
54
Rep. gr.10 - Removing and installing engine