Seat Ateca 2017 Workshop Manual page 41

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Continued for all vehicles:
Note
Use a cloth to catch the escaping coolant.
– Loosen hose clips -arrows- and remove coolant hoses from
gear oil cooler.
– Seal open lines and connections with suitable plugs from en‐
gine bung set - VAS 6122- .
– Unscrew bolts -1 to 9- securing gearbox to engine.
Note
Disregard -Item A-.
– Separate gearbox from engine.
– Before assembling, renew needle bearing in crankshaft
⇒ page 82 .
1.2.3 Separating engine and gearbox, vehi‐
cles with 6-speed dual clutch gearbox
Special tools and workshop equipment required
♦ Workshop hoist - VAS 6100-
♦ Adapters - 10 - 222 A /20-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1. Removing and installing the engine
33