Checking Adjustment Of Assembly Mountings - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Unscrew gearbox mounting bolts -arrows- one after the other
and renew them (if not already renewed when installing en‐
gine).
– First screw bolts in loosely.
– On gearbox side, ensure that support arm and gearbox mount‐
ing are parallel.
• Dimension -x- = dimension -x-.
– Tighten bolts for gearbox mounting.
Specified torques
♦ ⇒ "2.1 Installation overview - assembly mountings", page 44
♦ ⇒ Electrical system; Rep. gr. 27 ; Battery; Battery - Exploded
view
2.7 Checking adjustment of assembly
mountings
Operation process
The following dimensions must be reached:
• There must be a distance of -a- = 10 mm between engine
support -2- and engine mounting -1-.
• Side surface of engine support casting should be located par‐
allel to support arm of engine mounting.
• Distance -b- = distance -b-.
Note
For example, distance -a- = 10 mm can be checked with a metal
rod of suitable size.
– If the distance measured is too large or small, the assembly
mountings must be adjusted
56
Rep. gr.10 - Removing and installing engine
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 55 .