Chain Drive; Assembly Overview - Camshaft Timing Chains - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
3

Chain drive

⇒ "3.1 Assembly overview - camshaft timing chains", page 128
⇒ "3.2 Assembly overview - drive chain for balancer shaft", page
130
⇒ "3.3 Fitting and removing bearing support module", page 132
⇒ "3.4 Removing and installing camshaft timing chain",
page 134
⇒ "3.5 Removing and installing drive chain for balancer shaft",
page 148
⇒ "3.6 Checking valve timing", page 148
⇒ "3.7 Checking timing chain", page 152
3.1 Assembly overview - camshaft timing
chains
Note
After working on the chain drive, adapt learnt values in engine
♦
control unit. To do this, switch on ignition, and select the fol‐
lowing menu options on vehicle diagnostic tester :
♦
0001 - Adaption diagnosis chain length
128
Rep. gr.15 - Cylinder head, valve gear
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.