Removing And Installing Mechanical Switching Valve - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
2.3 Removing and installing mechanical
switching valve
Removing
– Remove engine oil cooler
– Remove mechanical switching valve -1- from ancillary bracket
-arrow-.
Fitting
Install in the reverse order of removal, observing the following:
Note
Renew gaskets and seals.
♦
Secure all hose connections with the correct type of hose clips
♦
(same as original equipment) ⇒ Electronic parts catalogue
(ETKA) .
– Moisten O-rings of mechanical switching valve with engine oil,
and install switching valve.
– Install engine oil cooler
218
Rep. gr.17 - Lubrication
⇒ page 216 .
⇒ page 216 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.