Seat Ateca 2017 Workshop Manual page 21

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Open filler cap -arrow- on coolant expansion tank.
– Remove engine cover panel
– Remove front parts of left and right front wheel housing liners
⇒ General body repairs, exterior; Rep. gr. 66 ; Wheel housing
liner; Assembly overview – front wheel housing liner .
– Release and pull off connector -1- on oil level and oil temper‐
ature sender - G266- .
– Unscrew bracket -2- from subframe.
– Remove subframe together with steering rack ⇒ Running
gear, axles, steering; Rep. gr. 40 ; Subframe; Removing and
installing subframe with steering rack .
– Disconnect electrical connector -1-. Lift retaining clip -2-, and
loosen hose clip -3-.
– Place drip tray for workshop hoist - VAS 6208- underneath.
– Pull off coolant hose and connection, and drain coolant.
– For reasons of space, remove the air filter housing together
with the intake hose
– Disconnect battery ⇒ Electrical system; Rep. gr. 27 ; Battery;
Disconnecting and connecting battery .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Remove battery tray -1- ⇒ Electrical system; Rep. gr. 27 ;
Battery; Removing and installing battery tray .
⇒ page 57 .
⇒ page 356 .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1. Removing and installing the engine
13