Seat Ateca 2017 Workshop Manual page 446

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Unscrew propshaft in the front bevel box -arrows-.
– By turning the spindle, the engine/gearbox unit is moved for‐
wards until there is a small tension. Avoid collisions of com‐
ponents.
– When detaching and fixing the propshaft, it is always neces‐
sary to ensure that the socket -arrow- is not damaged.
– Detach propshaft of the bevel box and place it to the side on
the left.
– Cover propshaft in the front area with a cloth to prevent dam‐
age to the surface coating.
Note
Risk of damage to flexible joint
♦
Do not allow the decoupling element to kink by more than 10°.
♦
Do not damage wire mesh on decoupling element.
– Disconnect the connector -1- of the oil level and temperature
sender - G266- .
– Remove pendulum support
– Connect the engine support - T50015A- -2- as shown in the
diagram.
♦ Screw a bolt M8 x 30 mm -1- with a washer into the threaded
hole of the subframe.
♦ Attach engine support - T50015A- -2- to support plate of po‐
sitioner - T10533/2- -4-.
♦ Fasten engine support - T50015A- assembly kit -2- and sup‐
port plate of positioner - T10533/2- -4- to the threaded hole of
the gearbox using bolt M12 x 20 mm of positioner - T10533/4-
-5-.
– By turning the spindle, the engine/gearbox unit is moved for‐
wards until there is a small tension. Avoid collisions of com‐
ponents.
438
Rep. gr.26 - Exhaust system
⇒ page 50 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.