Seat Ateca 2017 Workshop Manual page 326

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Removing
– Unscrew bolt -2- and remove screw-type clip.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
– Remove nuts -1 and 3-.
Note
Ignore -item 4-.
– Unscrew bolts -arrows-, and place catalytic converter to one
side
– Switch on ignition and select the following menu item in the
vehicle diagnostic and service information system :
♦
0001 - Adjust charge pressure positioner V465
– Follow instructions of vehicle diagnostic tester .
Adjusting
– Insert setting gauge - T40346- .
– Loosen lock nut -1-.
– Adjust linkage -arrow -of charge pressure positioner - V465-
according to instructions on vehicle diagnostic tester .
– Tighten lock nut -1- to specified torque.
– Remove setting gauge - T40346- .
Specified torques
♦ ⇒ "1.1 Exploded view - turbocharger", page 307
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
318
Rep. gr.21 - Turbocharging/supercharging