Removing And Installing Radiator Cowl - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Swing water radiator for charge air cooling circuit into lock
carrier. Ensure proper seating of radiator mountings -1- in lock
carrier.
Vehicles with bearing support for charge-air cooler, bolted.
– Use bolts to secure radiator mountings, whose fasteners have
been pinched off, to lock carrier. Screws -2- ⇒ ETKA (elec‐
tronic spare parts catalogue) .
• Tightening torque: 5 Nm
Continued for all vehicles
– Install radiator cowl
– Connect coolant hose with plug-in connector
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Install the front headlights ⇒ Electrical System; Rep. gr. 94 ;
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Headlights; Assembly overview - Headlights .
– Install front bumper ⇒ General body repairs, exterior; Rep. gr.
63 ; Front bumper; Removing and installing front bumper cov‐
er .
– Fill with new coolant
Specified torques
♦ ⇒ "4.1 Exploded view - radiator/radiator fans", page 291
♦ ⇒ Electrical system; Rep. gr. 94 ; Headlight; exploded view:
headlight
♦ ⇒ General body repairs, exterior; Rep. gr. 63 ; Front bumper;
Removing and installing bumper cover
4.5

Removing and installing radiator cowl

Removing
– Remove air filter housing
– Lay coolant hose -3- to one side.
– Unscrew bolts -1-.
– Release locking lugs-arrow-, unclip air hose -2- from the front
end and remove in -direction of the arrow-.
300
Rep. gr.19 - Cooling
⇒ page 300 .
⇒ page 244 .
⇒ page 356 .
⇒ page 292 .