Seat Ateca 2017 Workshop Manual page 30

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Vehicles with catalytic converter
– Loosen clamp -arrow-, and push it to rear.
– Remove catalytic converter -1-.
Vehicles with all-wheel drive
– Unscrew screws -arrows- with the bit - 3247- and remove heat
shield -1-.
Continued for all vehicles
– Unbolt drive shafts from flange shafts on left and right ⇒ Run‐
ning gear, axles, steering; Rep. gr. 40 ; Drive shaft; Removing
and installing drive shaft .
– Tie up the drive shafts towards the rear.
Note
Take care not to damage the surface coating of the drive shaft.
– If fitted, release electrical connector for auxiliary hydraulic
pump 1 for gearbox oil - V475- -a-, and pull off connector -b-.
22
Rep. gr.10 - Removing and installing engine
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.