Disconnecting Exhaust Pipes/Silencers - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Unscrew bolt -1- from the body.
– Unfasten clamps -arrows-.
– Remove silencer -2-.
Fitting
Install in the reverse order of removal, observing the following:
– Align exhaust system without tension
Specified torques
♦ ⇒ "1.1.5 Assembly overview - silencers, engine codes CJXA,
CJXE, CJXH, Leon SC, 5-door", page 396
1.5

Disconnecting exhaust pipes/silencers

⇒ "1.5.1 Separating exhaust pipes/silencers, front-wheel drive",
page 408
⇒ "1.5.2 Disconnect exhaust gas pipe/silencer, Cupra ST Carbon
Fiber Kit", page 410
1.5.1 Separating exhaust pipes/silencers,
front-wheel drive
♦ The connecting pipe can be cut through at the cutting point in
order to renew the centre and rear silencers separately.
♦ The separating point is marked with indentations on the out‐
side of the exhaust pipe.
Special tools and workshop equipment required
♦ Chain-type pipe cutter - VAS 6254-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ Or
408
Rep. gr.26 - Exhaust system
⇒ page 411 .