Seat Ateca 2017 Workshop Manual page 185

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
With markings on cylinder head
– Turn vibration damper to TDC position using counter-hold tool
- T10355- .
• Notch on vibration damper must align with arrow marking on
timing chain cover (bottom) -arrow-.
• Markings -1- on camshaft chain sprockets must be aligned
with markings -2 and 3- on cylinder head.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Without markings on cylinder head
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Turn vibration damper to TDC position using counter-hold tool
- T10355- .
• Notch on vibration damper and marking on cover for timing
chains (bottom) must be aligned -arrow-.
• The markings -1- on the camshafts must face upwards.
– Use a permanent marker to mark on the camshaft timing chain
and the cylinder head-arrow- the matching with the chain
sprockets -1-.
– Use a permanent marker to also mark the camshaft timing
chain in coordination with the guide rail of the camshaft timing
chain -2-.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
177
4. Valve gear