Seat Ateca 2017 Workshop Manual page 410

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
1.2.2 Removing and installing rear silencer,
engine codes CJSA, CJSB
Note
In original factory equipment, this is a single piece with the rear
♦
silencer. Can be renewed individually for repair purposes.
The connecting pipe -A- can be cut through at the separating
♦
points in order to renew the rear silencers separately
⇒ page 408 .
Removing
– Detach mounting -1- from the silencer.
– Loosen clamp -arrow- and push towards rear.
CAUTION
Risk of accident caused by high weight of silencers.
– Seek help from a second a mechanic for the following work.
– Unscrew bolt -2- from the body. Remove silencer -3-.
Fitting
Install in the reverse order of removal, observing the following:
– Align exhaust system free of stress
Specified torques
♦ ⇒ "1.1.2 Assembly overview - silencers, engine codes CJSA ,
CJSB, Leon SC, 5-door", page 393
1.2.3 Removing and installing rear silencer,
engine codes CJXA , CJXA, CJXE,
CJXH, CJXC, CJXG
Note
In original factory equipment, this is a single piece with the rear
♦
silencer. Can be renewed individually for repair purposes.
The connecting pipe -A- can be cut through at the separating
♦
points in order to renew the rear silencers separately
⇒ page 408 .
For engine codes CJXH, CJXC and CJXG no middle silencer
♦
is fitted.
402
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 411 .