Seat Ateca 2017 Workshop Manual page 27

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Vehicles with manual gearbox
– Unplug electrical connector -2-.
– Push back cover -1- for positive battery terminal and unscrew
positive wire from starter solenoid switch.
– If present, unscrew the nut -3- hand remove the earth wire.
Note
Depending on vehicle version, the earth wire is secured to the
starter bolt.
– Disconnect the electrical plug connectors -1- and -2- on the
front left of the gearbox:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
1 - For gearbox neutral position sender - G701-
2 - For reversing light switch - F4-
– Disconnect gear selector cable and gate selector cable from
gearbox. Then, unbolt cable support bracket, and lay it to one
side together with cables ⇒ Rep. gr. 34 ; Selector mechanism;
Removing and installing selector mechanism .
– Detach line leading to clutch slave cylinder ⇒ Rep. gr. 30 ;
Clutch mechanism; Removing and installing clutch slave cyl‐
inder .
Vehicles with dual clutch gearbox
– Disconnect connector -1-.
– Push back cover for battery positive terminal -3-, and unbolt
battery positive cable from starter solenoid switch.
– Loosen nut -arrow-, and remove earth wire.
Note
Depending on vehicle version, the earth wire is secured to the
starter bolt.
– Touch earth with your hand (without gloves) to discharge any
static electricity.
– Do NOT touch connector contacts in gearbox connector with
your hands.
– Turn retainer catch anti-clockwise and unplug electrical con‐
nector -2- for mechatronic unit for dual clutch gearbox - J743- .
– Disconnect selector lever cable from gearbox, and pull it out
of cable support bracket ⇒ Rep. gr. 34 ; Selector mechanism;
Removing and installing selector mechanism .
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1. Removing and installing the engine
19