Seat Ateca 2017 Workshop Manual page 331

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Release hose clip -1- and -2-, and remove right charge air
hose.
– Seal off open pipes/lines and connections immediately with
clean plugs from engine sealing cap set - VAS 6122- .
Vehicles with bearing support for charge-air cooler, clipped in.
– Release catches -arrows- of bearing support for charge-air
cooler -1- on left and right, or pinch them off using side cutters.
Note
The bearing support for charge-air cooler is re-used during in‐
stallation. It will then be bolted to lock carrier. Screws ⇒ ETKA
(electronic spare parts catalogue) .
Vehicles with bearing support for charge-air cooler, bolted.
– Unscrew the screws -2- of the bearing support for charge-air
cooler -1- right and left.
Continued for all vehicles
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
– Press cooler on the top edge in the direction of the engine.
– Lift charge-air cooler out of the lower supports and press back‐
wards.
– Press catches -1- on both sides in -direction of arrow A- to
release them.
– Pull the condenser -3- upwards in -direction of arrow B-, and
detach it from charge-air cooler -2-.
– Tie up condenser on lock carrier.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
2. Supercharger air system:
323