Removing And Installing Balance Shaft - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
❑ The gear ring for needle bearing is colour coded. A gear ring for needle bearing with the same colour
coding must be installed
9 - Bolt
❑ Renew
❑ 4 Nm + +45° further
Tube for balance shaft - installation position
The openings -arrow- must face chain side.
4.2

Removing and installing balance shaft

⇒ "4.2.1 Removing and installing inlet side balance shaft",
page 88
⇒ "4.2.2 Removing and installing exhaust side balance shaft",
page 91
4.2.1 Removing and installing inlet side bal‐
ance shaft
Needle bearing must be renewed after each removal. Install new
needle bearing with same colour code.
Removing
• Engine is removed.
– Remove toothed belt for coolant pump
– Remove timing chain cover (top)
– Remove lower timing chain cover
– Remove camshaft timing chain and drive chain for balance
shafts ⇒ page 134 .
88
Rep. gr.13 - Crankshaft group
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 273
⇒ page 121 .
⇒ page 123 .
.