Injectors: Removing And Installing - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
2.3

Injectors: removing and installing

⇒ "2.3.1 Removing and installing injectors, direct injection", page
346
⇒ "2.3.2 Removing and installing injectors, indirect injection",
page 349
2.3.1 Removing and installing injectors, direct
injection
Note
Injectors from different manufacturers are used. For allocation to
the engine, refer to ⇒ ETKA (Electronic parts catalogue) .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Distinguishing between combustion chamber injectors
respect to the correctness of information in this document. Copyright by SEAT S.A.
Version -A-
Pull injector out of cylinder head
Version -B- with bead -arrow-
Pull injector out of cylinder head
Special tools and workshop equipment required
♦ Tool set for FSI engines - T10133 C-
Removing
Note
Injectors must only be installed when the engine is cold.
– Removing fuel rail ⇒ page 345
– If the injectors remain in the fuel rail, carefully pull the injectors
out of the fuel rail.
Remove injectors if they remain in cylinder head.
– Cover open intake ports with a clean cloth.
– Remove support ring -5- from injector -2-.
– Separate connector from injector that is to be removed, and
pull off support ring.
346
Rep. gr.24 - Mixture preparation - injection
⇒ page 347
⇒ page 348
.