Seat Ateca 2017 Workshop Manual page 73

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Turning crankshaft without vibration damper
– Fit turning over tool -A- on clamping pin. Pay attention to teeth
of chain sprocket while doing so. In TDC position the flat sec‐
tion of the tool faces upwards. Tighten turning over tool with
flange nut -B-.
– Now, the crankshaft can be turned on hexagon -arrow-.
Install vibration damper:
– If necessary, remove flange nut -B- and turning over tool -A-
from clamping pin.
– Fit vibration damper in TDC position. Pay attention to teeth of
chain sprocket -arrow- while doing so.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1. Cylinder block (pulley end)
65