Seat Ateca 2017 Workshop Manual page 34

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Further for models with all-wheel drive
– Unscrew bolts -A- and -B- from bevel box and remove heat
shield -1-.
– Mark the position of the propshaft to the flange of the bevel
box.
– To loosen and tighten propshaft, counterhold on rear final
drive.
– Unscrew propshaft in the front bevel box -arrows-.
– Loosen clamp -1- between catalytic converter and front si‐
lencer, and push it in direction of travel -arrow-.
26
Rep. gr.10 - Removing and installing engine
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.