Removing And Installing Sump (Top Section) - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Apply the bead of silicone sealant onto the clean sealing sur‐
face of the sump (bottom section), as illustrated.
♦ Thickness of sealant bead: 2 to 3 mm
Note
The line of sealant must not be thicker than prescribed, as
♦
otherwise excessive sealant will enter the sump and obstruct
the strainer in the oil intake pipe.
The oil pan must be installed within 5 minutes after applying
♦
the silicone sealant.
After fitting sump, allow the sealant to dry for approx. 30 mi‐
♦
nutes. Then (and only then) fill the engine with engine oil.
– Tighten new bolts -1- to -20- in two stages in the sequence
shown:
Stage
1. Bolts -1- to -20-
2. Bolts -1- to -20-
– Replenish engine oil and check oil level ⇒ Maintenance ;
Booklet 501 ; Engine oil: Draining; Renewing oil filter and re‐
plenishing engine oil .
Specified torques
♦ ⇒ "1.1 Exploded view - sump/oil pump", page 200
1.4 Removing and installing sump (top sec‐
tion)
Special tools and workshop equipment required
♦ Assembly tool - T10118-
208
Rep. gr.17 - Lubrication
Tightening sequence and tight‐
ening torque
Tighten to 8 Nm
Turn 45° further
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.