Seat Ateca 2017 Workshop Manual page 120

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Disconnect plug-in connectors:
1 - for throttle valve control unit - GX3-
2 - for intake manifold sender - GX9-
3 - For fuel pressure sender - G247-
– Detach electrical connector -4- from bracket.
– Move electrical wiring harness clear and press to one side.
– Vehicles with auxiliary radiator (left-side): Move coolant hose
-3- clear.
– Move electrical wiring harnesses -1, 2- clear at air pipe.
– Release the hose clamp -4-.
– Unscrew bolts -arrows- and detach air pipe downwards.
– Remove electrical connector -3- for knock sensor 1 - G61-
from bracket and unplug connector.
– Disconnect connectors -2 and 4-.
– Separate connectors and lay wiring harnesses to one side:
1 - For intake manifold flap valve - N316-
2 - For coolant shut-off valve - N82-
3 - for coolant temperature sender - G62-
4 - For stage 3 oil pressure switch - F447-
– Remove bolts -arrows-.
112
Rep. gr.15 - Cylinder head, valve gear
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.