Seat Ateca 2017 Workshop Manual page 117

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Unscrew bolts -arrows- and nut -1-.
– Detach heat shield -2-.
For vehicles with particulate filter
– Remove bolts -arrows- and nuts -1-.
– Remove heat shield -2-.
– Disconnect electrical connector -arrow-from pressure differ‐
ential sender for particulate filter - G1037- .
– Unscrew bolts -arrows- on bracket for pressure differential
sender for particulate filter - G1037- -1-.
– Move bracket for pressure differential sender for particulate
filter - G1037- -1- to the rear and tie it up.
Continued for all vehicles
– Remove lambda probe 1 before catalytic converter - GX10-
⇒ page 388 .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
EA 888 III. Gen) - Edition 10.2018
1. Cylinder head
109