Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
•
Installation position of the actuators for camshaft adjuster.
– Press in pin of actuator for camshaft adjustment -arrow- by
hand.
•
The dowel pin of the actuator may not be in an unlocked po‐
sition.
– Install engine cover panel
Specified torques
♦
⇒ "4.1 Assembly overview - valve gear", page 153
4.7
Removing and installing valve stem
seals
⇒ "4.7.1 Removing and installing valve stem oil seals (cylinder
head installed)", page 188
⇒ "4.7.2 Removing and installing valve stem oil seals (cylinder
head removed)", page 193
4.7.1
Removing and installing valve stem oil
seals (cylinder head installed)
Special tools and workshop equipment required
♦ Spark plug socket and extension - 3122B-
♦ Valve stem seal puller - 3364-
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
188
Rep. gr.15 - Cylinder head, valve gear
⇒ page 57
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
respect to the correctness of information in this document. Copyright by SEAT S.A.