Seat Ateca 2017 Workshop Manual page 84

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
♦ Sealant ⇒ Electronic parts catalogue (ETKA)
Removing
• Gearbox removed.
– Remove flywheel ⇒ page 74
– Detach intermediate plate at sealing flange and dowel sleeves
-arrows-.
– Unscrew bolts -1 ... 8-.
– Remove sealing flange.
Fitting
Install in reverse order of removal, observing the following:
Note
Observe use-by date of silicone sealant.
♦
The sealing flange should be fitted into place 5 minutes after
♦
the application of the sealant.
In order to prevent the lubrication system from being soiled
♦
with sealant residue cover the open section of the sump with
a clean cloth.
CAUTION
Risk of eye injury caused by sealant residue.
– Wear safety goggles.
– Remove sealant remaining on cylinder block with flat scraper
or rotating plastic brush.
– Clean sealing surfaces. They must be oil and grease free.
– Clean crankshaft journal. If there is any rust, lightly coat crank‐
shaft journal with oil.
76
Rep. gr.13 - Crankshaft group
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.