Seat Ateca 2017 Workshop Manual page 417

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
♦ Pneumatic sabre saw - V.A.G 1523B-
Sequence of operations
– Cut through exhaust pipe -1- at right angles at separating point
-arrow- using chain pipe cutter - VAS 6254- or pneumatic sa‐
bre saw - V.A.G 1523B- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Position clamp -arrow- centrally relative to side marks when
installing.
– Install the clamp so that end of bolt -arrow- does not extend
beyond lower edge of clamp.
– Align exhaust system without tension
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
⇒ page 411 .
EA 888 III. Gen) - Edition 10.2018
1. Exhaust pipes/silencers
409