Seat Ateca 2017 Workshop Manual page 118

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Lay coolant hose -3- to one side.
– Unscrew bolts -1-.
– Release locking lugs-arrow-, unclip air hose -2- from the front
end and remove in -direction of the arrow-.
– Release hose clip -2- and detach air hose from charge air
cooler.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Note
respect to the correctness of information in this document. Copyright by SEAT S.A.
Disregard -item 1-.
– Seal open lines and connections with clean plugs from engine
bung set - VAS 6122- .
– Release the hose clamp -2-.
– Free coolant hose -3-.
– Remove bolts -arrows-.
– Unplug electrical connector -1- at charge pressure sender -
G31- and detach air pipe (right-side).
– Release hose clip -1- and detach air hose from charge air
cooler.
110
Rep. gr.15 - Cylinder head, valve gear