Removing And Installing Coolant Valve For Gearbox - N488- , Vehicles With Dual Clutch Gearbox - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Pull off connector -2-.
– Use hose clamps -N82- to clamp off coolant hoses on coolant
shut-off valve - 3094- .
Note
Place a cloth underneath to catch escaping coolant.
– Release hose clips -1- and disconnect coolant hoses.
– Unscrew bolt -arrows- and detach coolant shut-off valve -
N82- .
Fitting
Install in the reverse order of removal, observing the following:
Note
Secure all hose connections with the correct type of hose clips
(same as original equipment) ⇒ Electronic parts catalogue (ET‐
KA) .
– Check coolant level
Specified torques
♦ ⇒ "2.2 Exploded view - electric coolant pump", page 270
♦ ⇒ "3.1 Exploded view - air cleaner housing", page 355
2.8 Removing and installing coolant valve
for gearbox - N488- , vehicles with dual
clutch gearbox
Special tools and workshop equipment required
♦ Hose clamps to Ø 25 mm - 3094-
280
Rep. gr.19 - Cooling
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 244 .