Seat Ateca 2017 Workshop Manual page 408

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
1.1.8 Assembly overview - silencers, Ateca Cupra
1 - Nuts
❑ Qty. 2
❑ 30 Nm
2 - Clamping sleeve
❑ Evenly tighten nuts
❑ Fitting position
⇒ page 401
❑ Aligning exhaust sys‐
tem free of tension
⇒ page 411 .
3 - Mounting
❑ Renew if damaged
4 - Nuts
❑ Qty. 3
❑ Specified torque
⇒ page 400
5 - Exhaust flap control unit 2 -
J945-
❑ Removing or installing
⇒ page 443
6 - Bracket
7 - Bolts
❑ 20 Nm
8 - Rear silencer
❑ Removing or installing
⇒ page 401
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
❑ Aligning exhaust sys‐
tem free of tension
⇒ page 411 .
9 - Exhaust flap control unit -
J883-
❑ Removing or installing
Exhaust flap control unit – specified torque
Component
Nuts -3-
Note
Renew nuts.
400
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 443
Tightening torque
3 Nm