Removing And Replacing Coolant Pump; Protected By Copyright. Copying For Private Or Commercial Purposes, In Part Or In Whole, Is Not - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
2.5

Removing and replacing coolant pump

Removing
– Remove toothed belt for coolant pump
– Remove the throttle control unit
– Disconnect electrical connectors -2, 3 and 4-. Remove fas‐
tening bolts -1- and move bracket to one side.
– Remove bolts -1 ... 4- and detach coolant pump from actuator
for engine temperature regulation - N493- .

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not

permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Fitting
Install in the reverse order of removal, observing the following:
– Fit coolant pump and placed toothed belt in position.
– Ensure that centring pins -arrows- and seal -3- are seated
correctly.
– Tighten coolant pump bolts
– After mounting a new coolant pump -2- remove protective cap
-1- from drive sprocket.
– Replenish coolant ⇒ page 240
Specified torques
♦ ⇒ "2.1 Exploded view - coolant pump and thermostat",
page 268
♦ ⇒ "3.1 Exploded view - air cleaner housing", page 355
276
Rep. gr.19 - Cooling
⇒ page 273
⇒ page 365 .
⇒ page 270 .
.
.