Seat Ateca 2017 Workshop Manual page 307

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Continued for all vehicles
– Turn radiator component with top edge towards the engine.
– Press down left and right locking pins -arrow- of the radiator.
Press radiator off charge air cooler.
– Remove radiator upwards.
Installation
Note
If there are minor dents in the fins, refer to respective instruc‐
♦
tions ⇒ page 10 .
Renew O-rings after removal.
♦
– Insert radiator at an angle into lower charge air cooler mount‐
ing, and engage radiator in charge air cooler -arrow-. Ensure
proper engagement by pulling.
Installation position of the bearing support for the charge-air cool‐
er
– Position right and left bearing support for the charge-air cooler
-1- on the cooler. When doing so, note the installation position
-arrow-.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
EA 888 III. Gen) - Edition 10.2018
4. Radiator/radiator fans
299