Seat Ateca 2017 Workshop Manual page 291

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Lift retaining clips -1- and disconnect coolant hoses.
Note
Ignore -item 2-.
– Pull connector -1- off actuator for engine temperature regula‐
tion - N493- .
– Remove bracket for electrical connector -1-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
– Remove bolts -1 ... 5-.
– Detach actuator for engine temperature regulation - N493-
from centring pins and pull actuator off engine oil cooler.
Fitting
Install in the reverse order of removal, observing the following:
Note
Renew gaskets and O-rings.
– Coat new O-rings -4- with coolant; coolants ⇒ Electronic Parts
Catalogue (ETKA) .
– Ensure that the centring bolts are fitted to the engine block and
if not, fit them.
– Fit connecting piece -2- into engine oil cooler -1-.
– Push actuator for engine temperature regulation - N493- -3-
onto connecting piece and centring pins in cylinder block.
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
2. Coolant pump/thermostat assembly
283