Seat Ateca 2017 Workshop Manual page 51

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Replenish coolant
If a new base engine or short engine was installed, additional
adaptations must be carried out in the engine control unit. To do
this, proceed as follows:
– Connect ⇒ Vehicle diagnostic tester, and select following func‐
tions.
♦
Engine control unit functions
♦
0001 - Oil pressure for entry into the engine
and
♦
Engine control unit functions
♦
0001- Basic setting
♦
0001 - Adaption diagnosis chain length
Specified torques
♦ ⇒ "2.1 Installation overview - assembly mountings",
page 44
♦ ⇒ "2.1 Assembly overview - emission control", page 414
♦ ⇒ "1.1 Exploded view - silencers", page 391
♦ ⇒ "3.1 Exploded view - air cleaner housing", page 355
♦ Securing gearbox to engine ⇒ Rep. gr. 34 ; Removing and
installing gearbox; Tightening torques for gearbox
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 240 .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1. Removing and installing the engine
43