Seat Ateca 2017 Workshop Manual page 341

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
18 - Electrical connectors for
❑ Knock sensor 1 - G61-
❑ Suction pipe throttle flap - N316-
❑ Fuel pressure sensor - G247-
❑ Intake manifold flap potentiometer - G336-
❑ Hall sensor - G40-
❑ Injectors (combustion chamber) N30 ... N33
❑ Location ⇒ page 338
19 - Fuel pressure sender (low pressure) - G410-
❑ Fuel pressure sender for low pressure - G410- must be installed with an adapter
❑ 15 Nm
❑ Location ⇒ page 337
❑ Removing and fitting
20 - Knock sensor 1 - G61-
❑ To remove, first remove coolant pump with thermostat
❑ 20 Nm
❑ Removing and fitting
21 - Intake manifold sender - GX9-
❑ comprising:
Intake air temperature sensor - G42-
Intake manifold pressure sender - G71-
❑ Location ⇒ Fig. ""View from above"" , page 337
❑ Removing and fitting
22 - Throttle valve control mechanism - GX3-
❑ comprising:
Throttle valve drive (electric power control) - G186-
Throttle valve drive angle sender 1 (electric power control) - G187-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 373
⇒ page 454
⇒ page 374
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
333
1. Injection system