Seat Ateca 2017 Workshop Manual page 407

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
1 - Tension sleeve
❑ Installation position
⇒ page 397 .
❑ Stress-free alignment of
exhaust system
⇒ page 411
❑ Tighten bolted connec‐
tions evenly
❑ 30 Nm
2 - Middle silencer
❑ Disconnecting exhaust
pipes/silencers
⇒ page 408
❑ Stress-free alignment of
exhaust system
⇒ page 411
3 - Retaining rings
❑ Renew if damaged.
4 - Support plate
5 - Bolt
❑ 20 Nm
6 - Separating point
❑ Disconnecting exhaust
pipes/silencers
⇒ page 408
7 - Rear silencer
❑ In the original factory
equipment, this is a sin‐
gle piece with the centre
silencer. Can be re‐
newed individually for
repair purposes.
❑ Removing and fitting
⇒ page 402
❑ Stress-free alignment of exhaust system
❑ Disconnecting exhaust pipes/silencers
8 - Bolt
❑ 20 Nm
⇒ page 411
⇒ page 408
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1. Exhaust pipes/silencers
399