Removing And Installing Rear Silencer - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Installation position of clamp
– Fit clamp in position shown. Bolt -arrow- must not protrude
beyond lower edge of clamp.
• Angle -α- = about 50°+20º.
• Nuts upwards.
1.2

Removing and installing rear silencer

⇒ "1.2.1 Removing and installing rear silencer, engine codes
CJSA, CJSB, Leon 2013", page 401
⇒ "1.2.2 Removing and installing rear silencer, engine codes
CJSA, CJSB ", page 402
⇒ "1.2.3 Removing and installing rear silencer, engine codes
CJXA , CJXA, CJXE, CJXH, CJXC, CJXG", page 402
⇒ "1.2.4 Remove and install silencer, Leon ST, Cupra ST Carbon
Fiber KIt", page 403
⇒ "1.2.5 Removing and installing rear silencer, Ateca Cupra",
page 404
1.2.1 Removing and installing rear silencer,
engine codes CJSA, CJSB, Leon 2013
Note
♦ In original factory equipment, this is a single piece with the rear
silencer. Can be renewed individually for repair purposes.
The connecting pipe -A- can be cut through at the separating
♦
points in order to renew the rear silencers separately
⇒ page 408 .
Removing
– Loosen clamp -arrow- and push towards rear.
CAUTION
Risk of accident caused by high weight of silencers.
– Seek help from a second a mechanic for the following work.
– Unscrew bolts -1- from the body. Remove silencer -2-.
Fitting
Install in the reverse order of removal, observing the following:
– Align exhaust system without tension
Specified torques
♦ ⇒ "1.1.1 Assembly overview - silencers, engine codes CJSA ,
CJSB, Leon SC", page 391
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 411
EA 888 III. Gen) - Edition 10.2018
.
1. Exhaust pipes/silencers
401