Ignition Coils With Output Stage: Removing And Fitting - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
7 - O-ring
❑ Renew if damaged
8 - O-ring
❑ Renew if damaged.
9 - Hall sensor - G40-
❑ Inspect O-ring for damage before fitting
❑ Removing and fitting
10 - Bolt
❑ 9 Nm
11 - O-ring
❑ Renew if damaged
12 - Engine speed sensor - G28-
❑ Inspect O-ring for damage before fitting
❑ Removing and fitting
13 - Bolt
❑ 9 Nm
1.2 Ignition coils with output stage: remov‐
ing and fitting
Special tools and workshop equipment required
♦ Puller - T10530-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Removing
– Remove engine cover panel
– If fitted, detach earth wire -1- of ignition coil to be removed,
and unscrew bolt -arrow-.
452
Rep. gr.28 - Ignition system
⇒ page 455
⇒ page 456
⇒ page 57 .