Removing And Installing Coolant Temperature Sender G62 - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Tighten bolts for actuator for engine temperature regulation -
N493- . ⇒ page 270
Note
The protective cap -arrow- must be removed if a new coolant
pump is going to be installed.
– Install coolant pump
– Replenish coolant ⇒ page 240
Specified torques
♦ ⇒ "2.1 Exploded view - coolant pump and thermostat",
page 268
♦ ⇒ "4.1 Exploded view - intake manifold", page 358
2.10 Removing and installing coolant temper‐
ature sender - G62-
Removing
• Engine cold.
– To relieve residual pressure in cooling system, open filler cap
-arrow- on coolant expansion tank briefly and then close cap
again (it should click into place).
– Remove air filter housing
– Release the hose clamp -2-.
– Remove bolt -1- and press air pipe (left-side) towards left
slightly.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
284
Rep. gr.19 - Cooling
⇒ page 276 .
.
⇒ page 356 .