Seat Ateca 2017 Workshop Manual page 28

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Vehicles with automatic gearbox
– Using an open-end spanner, for example, lever selector lever
cable -1- off gearbox selector lever -2-.
– Pull connector -6- off multifunction switch - F125- and lay elec‐
trical wiring on bracket aside.
– Unscrew bolts -5- from cable support bracket -4-. Do not de‐
tach securing clip -3-.
– Unhook selector lever cable -1- from securing clip -arrow-.
Note
Do not bend or kink gear selector cable.
♦
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
To ensure that the cable is not a hindrance when removing
♦
and installing the gearbox, raise the cable to a suitable position
on the body and tie using e.g. cable ties.
– Detach electrical connector from gearbox as follows. Push
locking mechanism -1- in direction of arrow, fold out bar -2-,
and pull connector -3- off gearbox.
– Separate electrical connectors from starter ⇒ Electrical sys‐
tem; Rep. gr. 27 ; Starter; Removing and installing starter .
Continued for all vehicles
– Loosen bolts -arrows- for gearbox mounting approx. 2 turns.
20
Rep. gr.10 - Removing and installing engine
respect to the correctness of information in this document. Copyright by SEAT S.A.