Removing And Installing Engine Support - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Moisten new O-rings -4- with coolant.
– Insert the connecting supports -2- into coolant pump housing
-3-.
– Move the ancillaries bracket -1- on the connecting hose, insert
the bolts and tighten
– Install air conditioner compressor ⇒ Rep. gr. 87 ; Air condi‐
tioner compressor; Exploded view - air conditioner compres‐
sor drive unit .
– Install alternator ⇒ Electrical system; Rep. gr. 27 ; Alternator;
Removing and installing alternator .
– Fit poly V-belt ⇒ page 60
– Replenish coolant
– Install oil filter and check oil level ⇒ Maintenance ; Booklet
501 ; Engine oil Draining; Renewing oil filter and replenishing
engine oil .
– Install the windscreen washer tank filler ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling windscreen washer tank .
Specified torques
♦ ⇒ "1.1 Exploded view - cylinder block (pulley end)", page 58
♦ ⇒ "2.1 Assembly overview - timing chain cover", page 119
♦ ⇒ Electrical system; Rep. gr. 27 ; Alternator; Exploded view
- alternator
♦ ⇒ Electrical system; Rep. gr. 92 ; Windscreen washer system;
Assembly overview - windscreen washer system
1.6

Removing and installing engine support

Special tools and workshop equipment required
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
♦ Accessories: - T10099-
respect to the correctness of information in this document. Copyright by SEAT S.A.
Removing
– Unclip lambda probe wire from retainers -arrows-.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
– Remove front part of right wheel housing liner ⇒ General body
repairs, exterior; Rep. gr. 66 ; Wheel housing liner; Removing
and installing front wheel housing liner .
– Remove engine mounting
⇒ page 59 .
.
⇒ page 240 .
⇒ page 45 .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1. Cylinder block (pulley end)
69