Removing And Installing Tensioner For Poly V-Belt; Removing And Installing Vibration Damper - Seat Ateca 2017 Workshop Manual

Hide thumbs Also See for Ateca 2017:
Table of Contents

Advertisement

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Fitting
Installation is carried out in the reverse order; note the following:
– Fit poly V-belt as shown in illustration.
1 -
Vibration damper
2 -
Tensioning device for V-ribbed belt
3 -
Alternator:
4 -
Air conditioner compressor
– Turn tensioner in direction of -arrow- and remove locking pin
- T10060 A- .
– Release the tension devices.
– Check that poly V-belt is properly seated.
Vehicles with washer fluid reservoir on right
– Install windscreen washer tank ⇒ Electrical system; Rep. gr.
92 ; Windscreen washer system; Removing and installing tank
for windscreen washer system .
– Start engine and check that poly V-belt runs properly.
Specified torques
♦ ⇒ Electrical system; Rep. gr. 92 ; Windscreen washer system;
Assembly overview - windscreen washer system
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Noise insula‐
tion; Assembly overview - noise insulation
1.3
Removing and installing tensioner for
poly V-belt
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Removing
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Detach poly V-belt from tensioner
⇒ "1.2 Removing and installing poly V-belt", page 60
– Remove bolts -arrows- and take off tensioner -1- for poly-V-
belt from bracket for ancillaries.
Fitting
Install in the reverse order of removal, observing the following:
– Fit poly V-belt
⇒ page 60
– Install the windscreen washer tank filler ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling windscreen washer tank .
Specified torques
⇒ "1.1 Exploded view - cylinder block (pulley end)", page 58
♦ ⇒ Electrical system; Rep. gr. 92 ; Windscreen washer system;
Assembly overview - windscreen washer system
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Noise insula‐
tion; Assembly overview - noise insulation
1.4
Removing and installing vibration damp‐
er
Special tools and workshop equipment required
.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
.
1. Cylinder block (pulley end)
61

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Leon 2013Leon st 2013

Table of Contents