Seat Ateca 2017 Workshop Manual page 319

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Unscrew bolt -1-, and open hose clip -2-.
– Move cables at air pipe.
– Remove charge-air pipe of the exhaust gas turbocharger.
Note
Seal the removed cooling system lines with the engine sealing
cap set - VAS 6122- , as a small amount of coolant escapes from
the hoses
– Disconnect the coolant hose -arrow- and seal the line using
the engine sealing cap set - VAS 6122- .
– Unplug electrical connectors -1- and -2-. Open retainer -3-.
– Unscrew the bolt -1- from the earth wire and disconnect the
coolant hoses -2- and 3, and seal the lines using the engine
sealing cap set - VAS 6122- .
– Remove the electrical connectors -arrow-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Unplug electrical connectors -1, 3-.
– Press release tabs on crankcase breather hose -2- and detach
hose.
– Unclip the guide rail staples and push the electrical wiring har‐
ness aside.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
311
1. Turbocharger