Seat Ateca 2017 Workshop Manual page 67

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
6 - Vibration damper
❑ With poly V-belt pulley
❑ Removing and fitting
❑ Crankshaft oil seal (pulley side): replacement
7 - Bracket for ancillary mechanical units
❑ With oil filter and engine oil cooler
❑ Removing and fitting
❑ Removing and installing engine oil cooler
8 - Gasket
❑ Renew
9 - Bolt
❑ Must be renewed if removed
❑ Tightening torque and sequence
10 - Bolt
❑ Tightening torque ⇒ Electrical system; Rep. gr. 27 ; Alternator; Alternator: Exploded view
11 - Alternator:
❑ Exploded view ⇒ Electrical system; Rep. gr. 27 ; Alternator; Alternator: Exploded view
12 - Dowel sleeves
❑ For air conditioner compressor
13 - Air conditioner compressor
❑ Do not unscrew or disconnect the refrigerant hoses or pipes
❑ Exploded view ⇒ Rep. gr. 87 ; Air conditioner compressor; Exploded view - air conditioner compressor
drive unit
14 - Bolt
❑ Tightening torque ⇒ Rep. gr. 87 ; Air conditioner compressor; Exploded view - air conditioner compressor
drive unit
Bracket for ancillaries - tightening torque and tightening sequence
– Fit bracket for ancillaries (first tighten bolt -4- by hand).
Note
Always renew bolts that are tightened with specified tightening
angle.
– Tighten bolts in sequence -1 ... 5- in 3 stages as follows:
Stage Bolts
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
1. respect to the correctness of information in this document. Copyright by SEAT S.A. -1 to 5-
2. -1 to 5-
3 -1 to 5-
⇒ page 61
⇒ page 67
⇒ page 216
⇒ page 59
Specified torques/turning further an‐
gle
Screw in by hand as far as stop
20 Nm
Turn 90° further
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
⇒ page 70
.
1. Cylinder block (pulley end)
59