Seat Ateca 2017 Workshop Manual page 155

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Screw in bolts -arrows- and securely tighten
⇒ Item 4 (page 106)
– Moisten holes -arrows- with engine oil.
Note
If a spring pin -1- is fitted, and if the bearing saddle is to be re-
installed, the spring pin must be driven back. Clamping sleeve
must be flush with bearing saddle at cylinder head end.
– Fit bearing saddle. Do not cant bearing saddle, while doing so.
Screw in bolts -1...6- by hand.
– If a clamping sleeve is installed, it is pulled into the cylinder
head together with bolt -1-.
– Remove the Pinning tool - T40267- .
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
147
3. Chain drive