Removing And Installing Pistons - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Installation position of bearing shell
– Position bearing shells in centre of conrod and conrod bearing
cap when fitting.
Dimension -a- must be identical on both sides.
Oil injector - installation position
• The side wall of the oil spray jet -1- must lie parallel to the
neighbouring crankshaft bearing -2-.
• Dimension -a- = dimension -a-.
5.2

Removing and installing pistons

Note
If pistons with 3-part oil scraper ring are installed without the pis‐
ton installation sleeve - T40347- , the oil scraper ring will be
damaged.
Special tools and workshop equipment required
♦ Mandrel - VW 222 A-
♦ Sleeve for installing the piston -T40347- , without illustration
98
Rep. gr.13 - Crankshaft group
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.