Seat Ateca 2017 Workshop Manual page 456

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Unscrew temperature sender in front of particulate filter -
G506- -2-.
Note
Disregard -item 1-.
Vehicles with front-wheel drive
– Unscrew temperature sender before particulate filter - G506-
-arrow-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Installation
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Install in reverse order of removal, observing the following:
• Take care to protect exhaust gas temperature sender from
knocks and impact: do not use exhaust gas temperature sen‐
sors which have fallen to the ground.
– To apply tightening torque on temperature sender in front of
particulate filter - G506- , use spanner - T10395/6- .
Vehicles with all-wheel drive
– Move temperature sender in front of particulate filter - G506-
to installation position:
• Angle -α- = max. 15°.
Vehicles with front-wheel drive
– Move temperature sender in front of particulate filter - G506-
to installation position:
• Angle -α- = max. 15°.
Specified torques
♦ ⇒ "3.1 Assembly overview - exhaust gas temperature regula‐
tion", page 445
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Underbody
cladding; Assembly overview - underbody cladding
3.2.2 Removing and installing temperature
sender after particulate filter - G527-
Special tools and workshop equipment required
448
Rep. gr.26 - Exhaust system