Exploded View - Hose Connections For Charge Air System; Charged Air Cooler: Removing And Fitting - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
2.2 Exploded view - hose connections for
charge air system
Fitting hose connections with fluted union
Note
The screw-type clips -A- on the charge air pipes must always be
tightened to 5.5 Nm. If the torque is too low or too high, the charge
air hose may slip off the charge air pipe during vehicle operation.
– Check all air hoses and pipes for firm seating and leaks before
carrying out tests or repairs.
– Clean connection couplings, pipe lines and air intake hoses
before installation. They must be free of oil and grease.
– Secure all hose connections with the hose clips corresponding
to original equipment ⇒ Electronic parts catalogue .
– Spray the worm screws of the used hose clips with penetrating
spray before installing.
2.3

Charged air cooler: removing and fitting

Special tools and workshop equipment required
♦ Engine bung set - VAS 6122-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ Drip tray for workshop hoist - VAS 6208-
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
2. Supercharger air system:
321