Removing And Installing Sealing Flange (Gearbox End) - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Insert counter-hold tool - 3067- in hole -B- of cylinder block.
– Loosen and remove flywheel bolts.
Fitting
Install in the reverse order of removal, observing the following:
Note
Renew the bolts tightened with specified tightening angle.
– Insert counter-hold tool - 3067- in hole -A- of cylinder block.
Specified torques
♦ ⇒ "2.1 Exploded view - cylinder block, gearbox end",
page 73
2.3 Removing and installing sealing flange
(gearbox end)
Special tools and workshop equipment required
♦ Guide piece - T10122/6- or -T10122/6A- from fitting tools -
T10122B- or -T10122C-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ Assembly aid - T10122/1- from fitting tools - T10122B- or -
T10122C-
♦ Hand drill with plastic brush attachment
♦ Protective glasses
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
2. Cylinder block, gearbox end
75