Removing And Installing Exhaust Camshaft Control Valve 1 N318; Removing And Installing Actuators For Camshaft Adjustment - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Removing
– Unplug connector -1- from exhaust camshaft control valve 1 -
N318- and connector -2- from camshaft control valve 1 -
N205- .
– Screw out bolts -arrows- and remove from camshaft adjuster
valve 1 - N205- -Item 4- and camshaft adjuster valve 1 (in the
exhaust) - N318- -Item 2-.
Fitting
Install in the reverse order of removal, observing the following:
Note
Renew seals and O-rings.
– Lubricate sealing surfaces of oil seals to inlet camshaft control
valve 1 - N205- / exhaust camshaft control valve 1 - N318- with
engine oil.
Specified torques
♦ ⇒ "2.1 Assembly overview - timing chain cover", page 119
4.5 Removing and installing exhaust cam‐
shaft control valve 1 - N318-
Work sequence
⇒ "4.4 Removing and installing camshaft control valve 1 N205 ",
page 186
4.6 Removing and installing actuators for
camshaft adjustment
Allocation
Removing
– Remove engine cover panel
– Unplug corresponding connector -2-.
– Unscrew bolt -1-, and remove actuator for camshaft adjuster.
Installing
Installation is carried out in the reverse order; note the following:
Note
Check for damage.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 57 .
EA 888 III. Gen) - Edition 10.2018
187
4. Valve gear