Seat Ateca 2017 Workshop Manual page 430

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
♦ Four-wheel drive vehicles: grommet - 3247-
♦ Engine support - T50015A-
♦ Supports of the positioner - T10533/2-
♦ Bolt M12 x 20 mm of the positioner - T10533/4-
♦ High-temperature paste ⇒ Electronic parts catalogue (ETKA)
Removing
Note
The catalytic converter is removed together with the front ex‐
♦
haust pipe.
Fit cable tie in same place when installing.
♦
– Disconnect connector -1- for Lambda probe 1 after catalytic
converter - GX7- .
– Lay wires on plenum chamber bulkhead to one side.
422
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.